Napco Security Technologies Alert 800 - Manual (Page 6)

your system includes the Once you enter your personal
Napco Digit-Key keypad you can code into the Napco Digit-Key
choose your own private code keypad, the red ARMED/MEMORY
to arm and disarm the Control light will go on to show the Control
Center. To program your code, Center is armed, and off to show
slide the switch (upper left hand it is disarmed. If you enter the
corner of your Control Center) wrong code, your alarm system will
into the LOAD position. Go to the fail to respond. Be sure to WAIT
Digit-Key keypad and enter any 5 SECONDS before attempting to
combination of numbers up to 6 re-enter your code.
digits (there is no zero). Use a
number you will remember such
as your birthday (12-s-47) rather
than something obvious like your
Slide the switch into the LOAD
address. The choose
become the only code the Digit-Key keypad. Return the
by your system. Return
to the Control Center and slide
switch to the RUN position.*
the switch to the RUN position.*
REMINDER: When arming or
YOUR SYSTEM respond, you may have entered
arming, if the red light does not
NOT OPERATE IN THE LOAD the wrong code. Wait 5 seconds
POSITION.
before trying to enter your code
again.
entering your personal code for the first time, or reentering your code
after an extensive power failure, enter the code again after moving the switch to
6 the RUN position. This will activate the keypad lights and arm the system.