NETGEAR FS518T - Manual (Page 15)

physical description 2-2
As Figure 2-1 shows, the Model FS518T switch is equipped with 16 auto-sensing
10/100 Mbps Fast Ethernet UTP ports. The network access speed for the
10/100 Mbps ports is automatically sensed and displayed on the front panel by
the 10 Mbps or 100 Mbps Link LEDs.
The 10/100 Mbps ports support only UTP cable using an 8-pin RJ-45 plug.
Each of the 10/100 Mbps ports uses vista RJ-45 connectors that have built-in
LEDs, as illustrated in Figure 2-2. The LEDs, as described in Table 2-1 on page 2-5,
indicate that the connection to the port is valid and that the port is operating at
either 10 or 100 Mbps.
For further information about the vista RJ-45 connector and the RJ-45 plug, refer
to Appendix B, “Connector Pin Assignments,” and Appendix C, “Cabling Guidelines.”
Key:
1 = 100M Link LED
2 = 10M Link LED
Figure 2-2. Vista RJ-45 Connector with Built-in LEDs
735EA
1 2
FS518T.Manual.FINAL 5/19/00 12:55 PM Page 16