NISSAN 2010 Sentra - Manual (Page 11)

SEEK/CAT BUTTONS AND TUNE/SCROLL DIAL
Press the SEEK/CAT buttons while a track is being played; the next track or the beginning
of the current track will be played.
Press and hold either SEEK/CAT (rewind or fast forward) button for more than approximately
1.5 seconds, the track will play while rewinding or fast forwarding. When the SEEK/CAT
(rewind or fast forward) button is released, the track will return to the normal playing speed.
use the SEEK/CAT buttons or the TUNE/SCROLL dial to scroll through the menu
(Playlists, Artists, Albums, Songs, Podcasts, Genres, composers and Audiobooks) and
press ENTER to make a selection.
if the system is turned off while the iPod ® is playing, the iPod ® will start when the PWR
button is pressed.
*XM ® Satellite Radio is only available on vehicles equipped with optional XM ® Satellite
subscription service.
USB INTERFACE (if so equipped)
The USB input jack is located in the center console. Remove
the protective cover from the USB jack, then insert the uSB
device into the jack. When a compatible storage device is
plugged into the jack, compatible audio files on the storage
device can be played through the vehicle’s audio system.
Press the AUX button to switch to the uSB input mode. depending on how the audio files
are encoded, information about the audio files (folder, Song, Artist, Track number and number
of Total Tracks in the folder) being played will be shown on the display screen of the vehicle.
CLOCK SET/DISPLAY ADJUSTMENT
Press the ENTER/SETTINGS button until the on-screen clock mode is displayed, then turn
the TUNE/SCROLL dial to toggle between clock display on or off.
To adjust the time, press the ENTER/SETTINGS button repeatedly until the clock Adjust mode
is displayed on the screen.
The hours will begin blinking, adjust by turning the TUNE/SCROLL dial left or right and press
the setting control knob.
The minutes will begin blinking, adjust by turning the TUNE/SCROLL dial left or right and
press the ENTER/SETTINGS button to set and exit.
9
REARVIEW MONITOR (if so equipped)
When the shift selector is moved to the R (Reverse)
position, the monitor display will automatically
change to show the area directly behind the vehicle.
The colored lines on the display screen indicate
approximate distances to objects.
Red 1.5 ft (0.5 m); Yellow 3 ft (1 m);
Green 7 ft (2 m) and 10 ft (3 m).