NEC XP29 Xtra - Manual (Page 2)

2
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE. ALSO DO NOT USE THIS UNIT'S POLARIZED PLUG
WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS, UNLESS
THE PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE
CABINET AS THERE ARE HIGH-VOLTAGE COMPONENTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER. NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
This symbol warns the user that uninsulated voltage within the unit may
have sufficient magnitude to cause electric shock. Therefore, it is danger-
ous to make any kind of contact with any part inside of this unit.
This symbol alerts the user that important literature concerning the opera-
tion and maintenance of this unit has been included. Therefore, it should
be read carefully in order to avoid any problems.
DOC compliance Notice
This Class A digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Warnings and Safety Precaution
The NEC MultiSync Multimedia monitors XP29 Xtra and XM29 Xtra are de-
signed and manufactured to provide long, trouble-free service. No mainte-
nance other than cleaning is required. Use a soft cloth and if necessary, mild
detergent. Do not use commercial spray cleaners which may damage the
surface. In case of damage, arrange for repairs at an authorized NEC Ser-
vice Center.
For operating safety and to avoid damage to the unit, read carefully and
observe the following instructions.
To avoid shock and fire hazards:
1. Provide adequate space for ventilation to avoid internal heat build-up.
Do not cover rear vents or install in a closed cabinet or shelves.
The unit is equipped with cooling fans at the rear. If you enclose the unit in
a cabinet or rack, be sure there is adequate space at the top and rear of
the unit to allow heated air to rise and escape. A cabinet or shelves in
which the unit is placed must be maintained below 40
° C
2. Do not use the power cord polarized plug with extension cords or outlets
unless the prongs can be completely inserted.
3. Do not expose unit to rain or moisture.
4. Avoid damage to the power cord, and do not attempt to modify the
power cord. Do not place the unit on the power cord. Damage to the
cord may cause shock or fire.
Handle the power cord carefully and avoid excessive bending. A
damaged cord can cause electric shock or fire.
5. Unplug unit during electrical storms or if unit will not be used over a long
period.
6. Do not open the cabinet which has potentially dangerous high voltage
components inside. If the unit is damaged in this way the warranty will be
void. Moreover, there is a serious risk of electric shock.
7. Do not attempt to service or repair the unit. NEC is not liable for any
bodily harm or damage caused if unqualified persons attempt service or
open the back cover. Refer all service to authorized NEC Service Cen-
ters.
To avoid damage and prolong operating life:
1. Use only with 100-120V/200-240V 50/60Hz AC power supply. Continued
operation at line voltages other than 100-120V/200-240 Volts AC will
shorten the life of the unit, and might even cause a fire hazard.
2. Handle the unit carefully when moving and do not drop.
3. Locate set away from heat, excessive dust, and direct sunlight.
4. Protect the inside of the unit from liquids and small metal objects. In case
of accident, unplug the unit and have it serviced by an authorized NEC
Service Center.
5. Unplug unit before cleaning. Use only a soft cloth and mild detergent.
Commercial household sprays and cleaners may damage the CRT sur-
face and cabinet.
6. Stacking of units, one top of another, may result in damage to the units.
Stacking is not recommended.
7. Do not place liquids on top of the unit. If liquid has been spilled into the
unit, unplug the unit and have it serviced by an authorized NEC Service
Center.
8. This unit is designed for indoor installation use only. Do not use the unit
for purposes other than originally intended.
9. Do not use the unit on an unstable surface.
10.Do not set the unit on end when in use or stock.
11.Rest your eyes periodically.
WARNING
This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
As an E NERGY S TAR ® partner, NEC Technologies has determined that
this product meets the E NERGY S TAR ® guidelines for energy efficiency.
E NERGY S TAR is a U.S. registered mark.