National Instruments Switch Executive - Manual (Page 8)

CVI TM , IVI TM ,LabVIEW TM , National Instruments TM , NI TM , ni.com TM , and TestStand TM are trademarks of
National Instruments Corporation. Product and company names mentioned herein are trademarks or
trade names of their respective companies. For patents covering National Instruments products,
refer to the appropriate location: Help»Patents in your software, the patents.txt file on your CD,
or ni.com/patents.
© 2001 – 2004 National Instruments Corporation.
All rights reserved. Printed in Ireland.
*371308A-01*
371308A-01 Jul04
Switch Control Functions
Miscellaneous Functions
Error Codes (continued)
VALUE VALUE
(HEX) (DECIMAL) DESCRIPTION
FILE_READ
FFFF8E9C –29028 An error occurred while attempting to read from file.
INVALID_MULTICONNECT_MODE
FFFF8E9B –29029 Invalid multiconnect mode.
INVALID_OPERATION_ORDER
FFFF8E9A –29030 Invalid operation order.
CONFIG_CHANNEL_CONFLICT
FFFF8E99 –29031 A reserved for routing channel required for connecting this route is
already in use by another route.
SOURCE_CHANNEL_CONFLICT
FFFF8E98 –29032 Connecting this route would cause excluded channels to be shorted
together.
ROUTE_EXISTS_WITH_DIFFERENT_MODE
FFFF8E97 –29033 The route you are trying to connect already exists with a different
multiconnect mode. It must be disconnected before you can make this
connection.
DISABLED_CHANNEL
FFFF8E96 –29034 The channel you are trying to use has been disabled for this virtual
device.
CANNOT_CONNECT_TO_ITSELF
FFFF8E95 –29035 You cannot connect a channel to itself. Either your endpoint channels are
the same or they reside on the same hardwire.
ROUTE_NOT_FOUND
FFFF8E94 –29036 Route cannot be found between the specified endpoints.
Programming Flow
The following diagram shows a typical programming flow for NI Switch Executive.
323249d.qxp 7/22/2004 4:39 PM Page 8