Napoleon Fireplaces EF30G - Manual (Page 11)

11
W415-0760 / 12.19.08
3.3.1 once the site has been prepared, the appliance can be installed.
3.3.2 make sure the main power switch is in the "off" position.
3.3.3 plug the appliance into a 15-amp/120 volt, grounded outlet. use a csa or ul approved surge protector.
3.3.4 Push in the appliance so that the trim is against the finished mantel or wall surface.
3.3 installing the appliance
3.4 glass ember installation
3.4.1 to remove the glass front, remove the two bottom screws as illustrated below.
3.4.2 lift the front up and pull forward and off. set the front in a location where it will not be knocked over or
damaged.
3.4.3 carefully distribute the glass embers into the bottom tray on the front of the appliance as illustrated.
3.4.4 re-install the glass front using the two securing screws.
BOTTOm
TraY
2 sCrEWs
glass
frONT
!
WARNING
Glass front must be removed and the fireplaces must be installed in it’s final location before the
glass embers are installed.
Glass embers may have sharp edges, wear safety glasses and gloves when handling.
tp - glass ember Warning