Napoleon Fireplaces EF30G - Manual (Page 15)

15
W415-0760 / 12.19.08
the controls are located on the bottom right corner of
the appliance.
5.0.1 plug in your electric appliance.
5.0.2 main on/off power switch and led:
- this switch is located on the right side of the
control panel. the "|" indicates on and "o"
indicates off.
- When the appliance is first turned on, the default
settings are as follows:
- ember bed: high
- flame: high
- appliance: off
5.0.3 temperature control button and led:
the appliance led is located to the right of the
flame button. push the temp button to cycle
through different appliance settings. press and
release the temp button to cycle through lo,
med, hi and off. each time the temp button
is pushed, the appliance led will change to its
corresponding color: green for lo, orange for med, red for hi, and blank for off. When the appliance
is turned on, heat will emit through the vents located in the middle of the top louvre panel. the appliance
has a built-in thermostat so it will shut off automatically once the pre-set temperature is reached. it will
also turn on automatically if the room temperature drops below the pre-set temperature. NOTE: When
the appliance is turned on for the first time, it may release a slight, harmless odour. This odour is
a normal occurrence caused by the initial heating of the internal heating elements and should
not occur again.
5.0.3 flame control button:
this button is located to the right of the temp button. after power is turned on, push the flame control
button to adjust the flame and ember bed brightness. Press and release the Flame Control Button to
cycle through lo, med, hi and off.
figurE 5.0.3
5.0 operating instructions