Napco Security Technologies GEM-X255 User Manual
Page 23
23
P R O G R A M M I N G ( O P T I O N A L )
Reviewing a Programmed User Code
To review an existing User Code, enter the 2-digit user number and the corresponding User Code will display.
Exiting the User Program Mode
When you have completed programming or erasing User Codes, press
C
to exit the User Program Mode.
Programming Example
Program the User 30 Code to “3784”:
1
Enter your User Code, followed by
A
.
2
Answer NO (press
F
) repeatedly until “ACTIVATE PROGRAM Y/N” is displayed, then press YES (
E
).
•
The display will read “ENTER USER CODE”
3
Press
030
for User No. 30, then press
A, A,
followed by
3784
.
4
Press
Jto save the code.
5
Press
C
to exit the Program Mode.
Notes:
•
If the system contains more than one keypad, only the keypad designated “No. 1” may be used for programming (if in
doubt which is No. 1, ask your installer).
•
While in Program Mode, the ARMED and STATUS lights remain off and burglar and fire alarm functions are disabled.
•
In selecting your codes, do not program repetitive numbers (1111), consecutive numbers (1234), your birth date, address,
or other obvious combinations. Choose a code of up to six digits (a minimum of four is recommended, and required in UL
installations).If the keypad detects no Program Mode activity for more than 4 minutes, a tone will sound. Press
C
to
silence.
GEM-X255_OI273_USER.pub
page 23
Tuesday, September 10, 2002 13:14