Napco Security Technologies GEM-X255 - Manual (Page 35)

35
S Y S T E M T R O U B L E E R R O R C O D E S
Trouble
Indication
System Trouble
Condition
Action
E19-00 User Program Memory Call installing company for service.
E20-00 Dealer Program
Memory Call installing company for service.
E21-00 System Shutdown Call installing company for service.
E22-NNN Sensor Watch Activity
Failure A Motion Sensor on the zone indicated has failed the programmed Sensor Watch activity test.
Insure that the sensor is able to detect activity in the area; clear any obstacles which may be
blocking the sensor from detecting activity. Press
C to clear the display, and then use the
Function Menu to Reset Sensor Watch Failure (see page 17). If you cannot correct the
problem yourself, call installing company for service.
E23-00 Burglary Bus Failure Call installing company for service.
E24-00 Service Message The system is in need of a preventive maintenance service call. Call installing company for
service.
E27-00 Printer Trouble A problem has been detected with the optional system printer. The following may cause
this trouble: (1) the printer has turned off, (2) the printer is off-line, (3) the printer interface
cable has been disconnected, and (4) the printer is
out of paper.
E39-00 Receiver Capacity
Error Call installing company for service.
GEM-X255_OI273_USER.pub
page 35 Tuesday, September 10, 2002 13:14