Net Optics 10/100/1000 - Manual (Page 6)


Installation Guide for 10/100/1000 Bypass Switch
Connecting the 10/100/1000 Bypass Switch to the
Network
1 ..Unpack.the.Bypass.Switch,.and.obtain.the.required.cables.needed.to..
successfully.install.the.unit ..
2 ..Connect.Network.Port.A.to.the.appropriate.switch,.server.or.router.device ..
This.will.act.as.your.DCE.Interface .
3 ..Connect.Network.Port.B.to.the.appropriate.switch,.server.or.router.device ..
This.will.act.as.your.DTE.interface .
4 ..Verify.that.the.Bypass.Switch.Network.Ports.are.cabled.in-line.between.two..
devices .
Connecting the 10/100/1000 Bypass Switch to the
Intrusion Prevention Device
1 ..Connect.Monitoring.Port.A.to.the.IPS.sensor.port.A.using.a.CAT5.RJ45.
cable ..This.will.act.as.your.DCE.Interface .
2 ..Connect.Monitoring.Port.B.to.the.IPS.sensor.port.B.using.a.CAT5.RJ45.
cable ..This.will.act.as.your.DTE.interface .
3 ..Verify.that.the.Switch.Monitoring.Ports.are.cabled.in-line.between.two.
devices .
Cabling Guidelines
10/100 Devices:
-. If.connecting.to.Switches.or.Hubs,.use.CAT5.RJ-45.Cross-over.cabling .
-. If.connecting.to.Routers.or.NIC.cards,.use.CAT5.RJ-45.Straight-thru..
cabling .
GigaBit Devices:
-. CAT5.RJ-45.Straight-thru.cabling .