NETGEAR XE102 - Manual (Page 16)

XE102 Wall-Plugged Ethernet Bridge User Guide
8
v1.0, June 2007
3. Select a PowerLine device.
4. Click Enter Password.
5. Enter the password from the label on the back of the selected PowerLine device, and click OK.
6. Repeat this step for all devices that you want attached to your network.
Setting the Network Password
To set the network password:
1. Click the Security tab.
Note: If more than one remote device is listed, you can identify each one from its
MAC address.
Figure 5
Figure 6