NETGEAR XE102 - Manual (Page 20)

XE102 Wall-Plugged Ethernet Bridge User Guide
12
v1.0, June 2007
HomePlug Light Not On
If the power light is on but the HomePlug light is not, check the following:
• Make sure that power is being provided to more than one PowerLine device. Another
PowerLine device must be installed for successful communication across the PowerLine.
• Verify that the network password is the same on all devices in the PowerLine network.
Ethernet Light is Off
• Make sure that the Ethernet cable is plugged in properly to a router LAN port.
• On the attached Ethernet device or network adapter card, check that the Link light is on.
Default Configuration Settings
The following table shows default settings for the XE102 Wall-Plugged Ethernet Bridge.
Table 8. PowerLine Device Default Configuration Settings
Feature Description
Network
Port Speed 10/100 Mbps, Auto-negotiation
Port Duplex Auto-negotiation
Auto uplink
Administration
Device password See product label.
PowerLine
Encryption password HomePlug