First period inaccuracy when using the timer, Nxp semiconductors – NXP Semiconductors UM10301 PCF2123 User Manual

Page 43

Advertising
background image

NXP Semiconductors

UM10301

User Manual PCF85x3, PCA8565 and PCF2123, PCA2125

UM10301_1

© NXP B.V. 2008. All rights reserved.

User manual

Rev. 01 — 23 December 2008

43 of 52

17. First period inaccuracy when using the timer

This chapter describes why the programmed delay is not always exactly as expected and
what to do in order to be as accurate as possible. The enable instruction for the timer is
generated by the I

2

C or SPI interface clock. This clock is asynchronous to the timer

source clock. The timer source clock is derived from the 32.768 kHz crystal frequency.
The consequences will be described here.

The RTCs for which this user manual was written include a countdown timer function,
except PCF8583 and PCF8593. The 8-bit countdown timer is controlled by the timer
control register. The timer control register determines one of 4 source clock frequencies
for the timer (4096 Hz, 64 Hz, 1 Hz or 1/60 Hz), and enables or disables the timer.

Table 10. Timer delays

Range of possible timer delays dependent on selected source clock frequency and n

Timer Source clock frequency

[1]

delay for n = 1

delay for n = 255

4096 Hz

244

μs 62.256

ms

64 Hz

15.625 ms

3.984 s

1 Hz

1 s

255 s

1/60 Hz

60 s

4 hrs 15 min

[1]

If the timer is not used, set source clock frequency to 1/60 Hz for power saving

Remark:

Note that all timings which are generated from the 32.768 kHz oscillator are

based on the assumption that there is 0 ppm deviation. Deviation in oscillator frequency
will result in deviation in timings.

001aaf906

n

duration of first timer period after
enable may range from n

1 to n + 1

03

xx

02

01

03

02

01

03

02

01

03

n

03

xx

countdown value, n

timer source clock

countdown counter

TE

TF

INT

In the example it is assumed that the timer flag is cleared before the next countdown period
expires and that the

INT is set to pulsed mode

Fig 20. General countdown timer behaviour

Advertising
This manual is related to the following products: