Nortel Networks T7406E - Manual (Page 19)

19
User Guide
Chapter 3
Preparing the handset for use
Complete the procedures in this chapter to
• install the charging cradle
• install the battery pack
• charge the battery pack in the handset for the first time
Installing the handset charging cradle
1 Plug the small end of the power adapter into the back of the charging cradle.
2 Plug the other end of the power adapter into an AC outlet near the location of the cradle.
3 Place the handset in the cradle to charge the battery.
Installing the battery pack
Complete this procedure if the battery pack is not already installed in your handset.
1 Use your thumb to slide the battery compartment cover down and off the back of the handset.
2 Position the battery pack in the bottom position inside the battery compartment.
3 Firmly press the top of the battery pack into place.
4 Replace the battery compartment cover.
Warning: You must complete the steps in this section when you first initialize a
base station and configure the first handset.