Northern Industrial Tools 157494 - Manual (Page 2)

2
Table of Contents
Important Safety Instructions 2 Safety Features 12
Grounding Instructions 3 Maintenance Instructions 13-15
Extension Cords 3 Moving and Handling Instructions 16
Specifications 4 Long Term Storage 16
Machine Component Identification 5 Troubleshooting Guide 17
Installation Instructions 6-9 Parts Breakdowns 18-19
Operation Instructions 10-11 Wiring Diagrams 20-21
Important Safety Instructions
WARNING -Risk of Injection or Injury to Persons - Do not direct discharge stream at persons. Do not use a
hose if exterior damage is evident.
-Risk of explosion - Do not spray flammable liquids. Do not operate in a flammable environment.
CAUTION -Risk of Asphyxiation - Exhaust fumes are deadly. For outdoor use only. Avoid inhaling exhaust
fumes.
-Risk of fire. Do not add fuel when the product is operating or hot.
-Gun kicks back. Hold with both hands.
-To reduce the risk of injury, read operating instructions carefully before use.
WARNING - When using this product, basic precautions should always be followed, including the following:
1.) Read all the instructions before using the product.
2.) Make sure that your existing hose, gun, and all accessories are rated for high temperatures and the
appropriate pressure.
3.) To reduce the risk of injury, close supervision is necessary when the product is used near children. Do
not allow irresponsible use by children. Always stop the product and bleed pressures before leaving
unattended, disconnecting hoses, or servicing.
4.) Know how to stop the product and bleed pressures quickly. Be thoroughly familiar with the controls.
5.) Stay alert - watch what you are doing.
6.) Do not operate the product when fatigued or under the influence of alcohol or drugs. Never smoke while
operating or fueling this machine.
7.) Keep operating area clear of all persons.
8.) Do not overreach or stand on unstable support. Keep good footing and balance at all times. Wear
footwear capable of maintaining a good grip on wet surfaces. Do not place the machine on soft or
unstable ground.
9.) Follow the maintenance instructions specified in all manuals.
10.) Wear safety glasses, gloves, face protection and appropriate clothing when operating the machine.
11.) Do not operate this machine with broken or missing parts. Never alter the manufacturer’s original design
or deactivate any safety device on the machine.
12.) Risk of exposure to dangerous chemicals. Wear protective gloves when handling and cleaning with
chemicals. Follow the chemical manufacturer’s directions. Understand all safety hazards and first aid for
all chemicals being used. Do not pump highly abrasive fluids or use with incompatible chemicals or
solvents.
13.) Know the pressure and temperature limits of your machine. Be sure all high pressure accessories meet
or exceed your machine’s limits. Do not set the pressure relief valve above the machine’s limit.
14.) Do not move this machine by pulling on the hose. Do not attempt to use this machine as a prop.
15.) Do not clean this machine with its own spray. Cleaning should be done with a damp sponge with the
machine OFF.
16.) NEVER attempt to immediately run or re-light the burner if it doesn’t ignite the first time. Unburned oil or
gas may have accumulated causing potential explosion or fire hazard.
17.) Always make sure all switches and controls are in the OFF position prior to plugging in the electrical
cord. Do no stand in water while plugging and unplugging electrical cord.
18.) This product is provided with a ground fault circuit interrupter built into the power cord plug. If
replacement of the plug or cord is needed, use only identical replacement parts. Failure to do so will
void all warranties.
SAVE THESE INSTRUCTIONS