Northern Industrial Tools 157494 - Manual (Page 9)

9
II.) Assembly Instructions
1. Attach handles, see above.
2. Attach wheels, see above.
3. Remove water heater from the pallet. It is recommended that a hoist is used, or that two people lift the unit
off of the pallet. If a hoist is used, use the attachment points shown in the Moving and Handling section on
page 16. Do not try to lift the unit by the hook on the heating coil inside the heat exchanger. The heating
coil is not secured to the frame.
To attach handles, use:
5/16 X .75” Flange Bolts (4x)
5/16 Flange Nuts (4x)
5/8 Hex Nut
5/8 Jam Nut
5/8 X 3.5” Hex Bolt
To attach wheels:
1.) Slide 5/8 X 3.5” bolt through
hub of wheel.
2.) Spin 5/8 Jam Nut onto bolt.
Do not tighten against wheel.
3.) Slide bolt through hole in
frame, secure with 5/8 Hex Nut.