Nikon LT170 - Manual (Page 16)

E-16
INSTALLATION AND CONNECTIONS
ZO OM
FO CU S
LAM P ME NU
SO UR CE ENTER
ST ATU S POW ER ON /ST AN D BY
SE LE CT
COMPUTER
S-VIDEO IN AUDIO IN
VIDEO IN
PU SH
CLOS E
Attaching the Projector to a Tripod
The projector can be used with a camera tripod.
To attach the projector to a tripod, use the supplied tripod adapter.
CAUTION
Care should be taken in handling a tripod.
Using the tripod on an unstable surface may result in the
tripod falling over or the projector falling which may result
in damage to the projector and possible personal injury.
Read the instructions supplied with your tripod for handling
and cautions.
• Use a tripod that can fully support the weight of the pro-
jector (approximately 5.5 lb/2.5 kg including attachment).
• Place the tripod with its feet fully open and weight evenly
distributed for stability.
• When using a tripod with a geared elevator, do not ex-
tend the geared elevator.
• When displaying an image in portrait mode (with the
projector on its side) (page E-13), be sure the tripod is
balanced for stability. Failure to do so may result in the
tripod falling over.
Preparation:
1. Disconnect all the cables.
2. A flat-blade screwdriver is required for attaching the sup-
plied three (3) screws. Use the supplied flat-blade screw-
driver.
1. Turn the projector upside down.
Place the projector on a soft cloth so as not to scratch the cabinet
surface.
2. Attach the supplied tripod adapter to the bottom of the
projector.
Secure the tripod adapter to the projector with the supplied (3) screws.
3. Attach the projector to the tripod.
Open the tripod to a fully extended position for greatest stability.
4. Connect all the cables.