Nortel Networks 2000 - Manual (Page 13)

Application Gateway Hardware Installation Guide
Chapter 1 Application Gateway Overview
Connectors
5
Back Connectors
Figure 2 shows the back of the Application Gateway.
Figure 2 Connectors on the back of the Application Gateway
Power-cord connector: Connect the power cord to this connector.
Serial connector: The DB-9 serial port is used to connect the Application
Gateway to a computer that is capable of running terminal emulation
software. This connection is used to access the Application Gateway Serial
Console during initial configuration.
Ethernet connectors: Typically, you connect Ethernet 2 network interface
(Interface 0) to the ELAN.
However, if the Application Gateway straddles two networks, use both
interfaces as follows:
•
The Ethernet 1 network interface (Interface 1) connects the
Application Gateway to the server-side network, directly or indirectly.
•
The Ethernet 2 network interface (Interface 0) connects the
Application Gateway to the client-side network.
Other connectors: These are not used for any function. Do not plug any
device into these connectors.