Nortel Networks 2000 - Manual (Page 20)

Chapter 2 Hardware Installation and Initial Configuration
Connecting and Powering up the Application Gateway
12 Application Gateway Hardware Installation Guide
To configure the Application Gateway using a serial console:
1
In the Application Gateway serial console, enter the default login root and
the default password rootadmin.
2
Type 0 and press Enter to choose Express Setup.
3
Enter the IP address and netmask for Interface 0 when prompted.
Note
The Application Gateway does not work with Dynamic Host
Configuration Protocol (DHCP). You must use static IP addresses
for the Application Gateway.
4
Enter the IP address of the gateway device when prompted.
A list of the settings displays.
5
Verify that the settings are correct.
If they are correct, type y when asked to commit your changes. The
Application Gateway restarts and displays the login prompt.
If they are not correct, type n when asked to commit your changes, then
type 0 (Express Setup) to change settings.
6
To test the connection, verify that the Application Gateway can ping
connected network devices: Type 1 (Ping), press Enter, and enter the IP
address that you want to ping.
If the ping is successful, you have completed the initial configuration. If
the ping is not successful, check your connections, return to the serial
console Main Menu, and type 0 (Express Setup) to change settings as
needed.
7
Install licenses as described in “Installing Licenses,” page 16 .
Refer to the Application Gateway Administration Guide for additional
operating information. You can download all documentation from the
Application Gateway Administration Tool.