Nortel Networks 2000 - Manual (Page 18)

Chapter 2 Hardware Installation and Initial Configuration
Connecting and Powering up the Application Gateway
10 Application Gateway Hardware Installation Guide
•
If the Application Gateway can access the connected device (router,
application server, etc.) from the same subnet as it receives client
requests, use one network cable. Connect Application Gateway
interface port 0 (ethernet 2) to your network. This is the typical
configuration.
•
If the Application Gateway will straddle two networks, use two
network cables:
–
Connect Application Gateway Interface 0 (ethernet 2) to the
client-side network.
–
Connect Application Gateway Interface 1 (ethernet 1) to the
server-side network, directly or indirectly.
The two network interfaces are shown in Figure 4 .
Figure 4 Ethernet Port Connectors
2
Connect a maintenance terminal to the Application Gateway.
a.
Connect a DTE–DTE null modem serial cable (supplied with the
Application Gateway) from the Serial Port on the back of the
Application Gateway to a maintenance terminal. The connection looks
like that shown in Figure 5 .
Figure 5 Application Gateway connection to Terminal
Serial Cable
Maintenance Terminal
Application Gateway