Numark Industries CD MIX-1 - Manual (Page 10)

CD MIX-1
- The Leader in DJ Technology
©1999 Numark Industries - 10 - http://www.numark.com
REAR PANEL FEATURES
1. Channels Inputs - Unbalanced RCA jacks for connecting external sources. The Phono/Line Input
is selected with the toggle switch on the front panel. You can connect stereo audio from
Turntables, HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, CD players, laser
discs, tuners, even synthesizers or other mixing consoles.
NOTE: Plug mono audio sources into both Left and Right inputs using a "Y" cable connector.
2. GND - Grounding lug for turntable connection. Always use this connection when using
turntables. (your turntable cable should have a grounding wire)
3. Line/Phono Input switch - Use this to allow either line level or phono level equipment to be
plugged into your channel inputs. When Phono input is selected, your signal is fed directly to the
high-quality RIAA phono pre-amplifiers. Use this position only for turntables. Line level sources will
overload the sensitive phono pre-amps and will sound very bad, so always be sure to toggle the
line/phono switch over to line before connection of line sources.
4. Record Outputs - Unbalanced RCA jacks used to send the output of the program any connected
recording device.
5. Stereo Main Outputs - Unbalanced RCA connectors controlled by the Master fader.
6. Balanced Main Outputs - Low-impedance XLR type connectors controlled by the Master fader.
7. Mic Input – Plug your 1/4” Microphone plug in here.
8. Power Connector - Plug in power adapter here and check the voltage level to match your
country’s standard.
9. Power Switch – Turn on unit here.