Numark Industries CD MIX-1 - Manual (Page 7)

CD MIX-1
- The Leader in DJ Technology
©1999 Numark Industries - 7 - http://www.numark.com
DESCRIPTION CD MIX-1 CD PLAYER FEATURES
1. OPEN/CLOSE (Disc Tray Open/Close) - Press to
load or eject the disc. Each press will open or close
the disc tray on the transport. NOTE: Tray will not
open unless the disc has been paused. Tray will
automatically close after 30 seconds.
2. TIME (Time Button) - Switches the time display
between elapsed playing time and remaining time on
the track and remaining time on the entire CD.
3. CONT/SING - Will cause just a single track to play or
all tracks in order by pressing once or twice.
4. LCD DISPLAY - Indicates all the functions, as they
are occurring, with the CD. These functions are
explained in the next section.
5. TRACK (Track Buttons) - Used to select the track
to be played.
6. Track 10 Button - This button is for quickly
advancing to higher tracks on a CD.
7. PROGRAM - Depress this button and the unit will
stop and the program indicator will light. Select
each track to be programmed and press the
PROGRAM button between selections. You can
program up to 30 tracks. Press PLAY to start the
program. To exit and erase program, either hold the
program button down for more than 2 seconds while
the unit is stopped, open the disc tray, or turn off the
power.
8. PITCH (Pitch Button) - Activates the Pitch Slider.
9. PITCH SLIDER - The pitch can be changed up to
+/-12% by pressing the PITCH button so the PITCH
LED is lit, then moving the sliding fader. The pitch will
not be changed if the PITCH LED is off.
10. SEARCH WHEEL (OUTER RING) - 3 forward and 3
reverse speed positions for searching through songs.
The more you turn the wheel in either direction the
faster you search through the music.
11. PITCH BEND/JOG WHEEL (INNER RING) - The jog
wheel serves 2 functions depending on the current
mode.
a) The jog wheel will control a slow frame search
when the CD is not playing. To set a new frame
cue point, spin the wheel then press play when you
have determined the proper position. Press CUE to
return to the “CUE POINT”.
b) When both CD players are playing a CD, the pitch
bend function allows the positioning of the bass
beats to be matched after the pitch of each disc is
matched. Either player can “catch up” or “fall back”
to match the other player. The jog wheel will
temporarily bend the pitch of the music if the song
is already playing by rotating the wheel clockwise to
speed up or counterclockwise to slow down. By
changing the pitch of one disc with respect to the
pitch of the other disc, the beats can be matched.
12. CUE - Pressing the CUE button during play provides a
return to the position at which play was started. If
PAUSE is used before CUE, that will become the cue
point. Alternately pressing the PLAY button and the
CUE button allows the CD to be played from the same
position any number of times. The CUE LED will light
up from the time the CUE button is pressed until the CD
has been reset to the position at which play was
started. Steady lighting of this LED indicates the ready
condition.
13. START/PAUSE (Play/Pause Button) - Each press of
the Play/Pause Button causes the operation to change
from play to pause or from pause to play.
14. BPM/PITCH BUTTON - Switches the mode of the
display between showing the BPM and the percentage
change in pitch.
15. TAP BUTTON - Tap this button with the beat of the
music to determine the current Beats Per Minute
(BPM).