Numark Industries CD MIX-1 - Manual (Page 14)

CD MIX-1
- The Leader in DJ Technology
©1999 Numark Industries - 14 - http://www.numark.com
BEFORE SWITCHING OFF THE POWER:
When you have finished using the CD player, be sure that the disc tray is closed with the
“OPEN/CLOSE” button before switching off the power.
DO NOT switch off the power when
the disc holder is open.
TROUBLESHOOTING:
Symptom Possible Cause Corrective Action
The power fails to switch on
when the POWER switch is set
to on Poor power plug connection at
the AC outlet or IEC Power cord
loose from rear of unit Insert the power plug firmly into
the AC outlet and make sure
connection is good in unit rear
Disc play does not start The disc is loaded upside down
The disc is too dirty
Reload the disc with the label
side up
Clean the disc
No sound Improper output cable
connections
Improper amplifier operation
Connect the output cables
correctly
Check amplifier setup
Sound skips The CD player is still subject to
vibrations or physical shock
The disc is too dirty
Change the installation location
Clean the disc
Programmed disc play will not
function The CD player is in normal disk
play mode Hold down the Program button
for 3 seconds then program the
tracks
Hum Loose cable connections Firmly connect all audio plugs