Nady Systems SM300A - Manual (Page 2)

(U.S.) Should your NADY AUDIO product require service, please contact the Nady Service Department via telephone at (510) 652-2411
or e-mail at [email protected].
(International) For service, please contact the NADY AUDIO distributor in your country through the dealer from whom you purchased
this product.
S E R V I C E
FOR YOUR NADY AUDIO PRODUCT
NADY SYSTEMS, INC. • 6701 SHELLMOUND STREET, EMERYVILLE, CA 94608
Tel: 510.652.2411 • Fax: 510.652.5075 • www.nady.com
S P E C I F I C A T I O N S
TECHNICAL DATA
Power
LED
indicator
9.5”
11.75”
(5)
(1)
(1) AC Power Cord IEC Connector — This standard IEC power cord receptacle features a built-in fuse holder for a 5X20mm, 3A
250V fuse (2A 250V for 230VAC operation).
(2) AC Voltage Selector Switch — Before plugging in the power cord, check to see that the unit is set for the proper voltage for
your area: ~115V (60Hz) or ~230V (50Hz).
(3) Power Switch — Use this switch to power the unit ON or OFF.
(4) Inputs — XLR and 1/4" TRS input jacks for line level signals. Use only one input at any time.
(5) Volume Control — Adjusts the level of the signal at the input. This can be set to maximum if the user prefers to control the
volume at the preceding unit.
(6) Clipping LED – Turns red when the output signal is clipping. It is acceptable if the red LED lights occasionally. If the red LED
lights more than occasionally, you should turn down the volume to avoid audible distortion and damage to the speaker.
Note: Speakers damaged due to hard clipping are not covered under warranty.
Woofer
Tweeter
(4)
(3)
(2)
(6)
FREQUENCY RESPONSE
16”