Nortel Networks 1110 - Manual (Page 24)

Connect the components
24
Figure 4: Remove the stand cover
2. Connect the AC power adapter (optional). Connect the AC power
adapter (not supplied) to the AC adapter jack in the bottom of the
phone (see
Figure 5 ). Form a small bend in the cable, and then
thread the adapter cord through the channel in the stand base. Plug
the AC power adapter into the nearest AC power outlet.
Note: Your IP Phone 1110 supports both AC power and Power over
Ethernet (PoE), including IEEE 802.3af standard power. To use AC
power, use only the Nortel-approved AC power adapter (RoHS Global
Power Supply, PEC #: N0089601), which can be ordered separately.
To use Power over Ethernet (PoE) power, your connected LAN must
support PoE; an AC power adapter is not required.
Tilt Lever
Button
Center
Catch
Handset
cord channel