NETGEAR ADSL2+ Modem Router DM111PSPv2 - Manual (Page 35)

ADSL2+ Modem Router DM111PSPv2 User Manual
Managing Your Modem Router 2-13
v1.0, December 2008
Remote Access
You can set up the modem router to allow remote access.
1. In the Advanced section of the main menu, select Remote Management. The following screen
displays:
2. Select the Internet connection for which you want to allow remote access from the drop-down
list.
3. Select the check box for the remote access that you want to allow. The selections are:
• Web Browser. Select this check box to configure remote control through HTTP. The
default port number is 8080. Choose a number between 0 and 65534, but do not use the
number of any common service port. To access the modem router, type the modem
router’s WAN IP address into your browser’s address field, followed by a colon (:), and
then the custom port number. For example, if your external address is 10.0.0.123 and you
use port number 8080, enter in your browser: http://10.0.0.123:8080.
• Telnet. Select this check box to configure remote control through telnet.
• TFTP. Select this check box to configure remote control through Trivial File Transfer
Protocol (TFTP).
Figure 2-12