Napco Security Technologies GEM-DXK3 - Manual (Page 10)

10
T U R N I N G O F F T H E AL AR M ( D I S AR M I N G ) W H E N R E T U R N I N G
Disarming the System
1. Enter your premises through the Entry/Exit door. The keypad will sound a steady tone to remind you to disarm the system
before your Entry Delay time expires.
2. Enter your User Code and press
U
. The red ARMED light will go out, indicating that the system has been disarmed.
• If you enter an invalid code, the keypad will beep 4 times, signifying an error. Re-enter your code immediately. 10 seconds
before Entry Delay expires, the keypad will emit a pulsing warning tone.
Alarm Indication / Silencing an Alar m
If the red ARMED light is flashing upon entry, an alarm occurred while you were out. (The display will scroll the number(s) of the
violated zone(s).) Proceed with caution! If you suspect that an intruder may still be on the premises, leave immediately and call
authorities from a neighbor's phone.
To silence an audible alarm:
1. Enter your code and press
U
. After the system is disarmed, the window will continue to display the number(s) of the zone(s)
violated.
2. To reset the display, note the zones violated, then press C .
Ambush (Optional) Your Ambush Code Type is: ‰TYPE 1 (Prefix) ‰TYPE 2 (Unique) My Ambush Code is ___________________
If an intruder forces you to disarm your system, enter your Ambush Code and press
U.
There are two types of Ambush Codes:
(1) A 2-digit code (prefix) entered just prior to your normal User Code and (2) A separate and unique User Code.
Example Type 1 (Prefix): If your User Code is 1234 and your Ambush Code is 99, press 991234
U.
Example Type 2 (Unique): If your User Code is 1234 and your Ambush Code is 8899, press 8899
U.
Using your Ambush Code will send a silent alarm to the central station. The red ARMED light will go out and the window will display
“SYSTEM READY” as if the system were normally disarmed. There will be no indication that a silent alarm has been sent.