Chassis -6, Figure 1-2 – National Instruments SCXI-1190/1191 User Manual
Page 14
Chapter 1
Installing and Configuring the SCXI-119X
1-6
www.ni.com
Figure 1-2. Connecting an SCXI Chassis to a DAQ Device or
Computer-Based Instrument
Connecting the SCXI-119X to a DAQ Device in a PXI Combination
Chassis
To connect the SCXI-119X to a DAQ device in a PXI combination chassis,
such as the PXI-1010 or PXI-1011, you need the following items:
•
PXI combination chassis with the SCXI modules installed
•
National Instruments PXI MIO DAQ device, or a computer-based
instrument that is capable of controlling SCXI, installed in the right
most slot of the PXI section of the combination chassis
A PXI combination chassis can use both SCXI and PXI modules at the
same time. Because the connection between the SCXI backplane and the
PXI backplane is made through a local bus interface to a PXI multifunction
I/O module installed in the right most slot, no external cabling is needed to
connect one PXI multifunction I/O module to the SCXI bus.
1
SCXI Chassis Power Switch
2
Cable Adapter
3
Cable
4
DAQ Device or Computer-Based Instrument
®
2
3
4
1