Napco Security Technologies MAGNUM 825 - Manual (Page 10)

Arming Wlth Selective
Zone Shunting
Your alarm specialist may have
opted for one or more zones that
can be selectively shunted
(removed) from the system. Since a
shunted zone cannot cause an
alarm, you may wish to use this
feature to turn OFF the interior
areas while arming, and keeping
your perimeter zones (windows,
doors, etc.) active.
To arm, check the green light to
make sure no zone is in trouble.
Press the shunt button ( labeled "S”),
and then the number of the zone (1
through 6) you wish to shunt
Your alarm specialist may also
have opted for interior zones to all
be “group shunt” zone-s Shunt
these zones simply by pressing the
"S" key twice. The yellow shunt light
will come ON whenever you shunt
one or more zones. Enter your arm/
disarm code to arm your remaining
zones. The green light will go OFF,
and the red ARMED/MEMORY light
will come ON. The yellow light will
go OFF when you disarm again indi-
cating that the shunted zones are
no longer shunted.( Note: The shunt
light does NOT come on when zones
are auto-shunted.)
Arming With
Instant Protectlon
Pressing key 4 (until you hear
a beep) will cancel the exit/entry
delay on the exit/entry zone when
arming. The red ARMED/MEMORY
light will flash rapidly to indicate
this condition. If someone enters
through the exit/entry zone, an
alarm will sound immediately.
Panic Zone
To activate the panic zone,
simultaneously press the two keys
marked * and # on the Digit-Key
keypad. The panic zone can be pro-
grammed to send a silent alarm to a
central station. activate an audible
alarm, or both.
10