NordicTrack COMMERCIAL NTL09707.1 - Manual (Page 15)

15
When the manual mode is selected, the console of-
fers eight display modes. The display mode that
you select will determine which workout information
is shown. For example, the first display mode
shows only the elapsed time and the distance that
you have walked or run. Press the Display button
repeatedly to select the desired display mode.
Regardless
of which
display
mode you
select, the
speed or
incline set-
ting will appear in the display for a few seconds
each time you change the setting. In addition, your
heart rate will appear in the display each time you
use the handgrip pulse sensor or put on the op-
tional chest pulse sensor. Note: If you select the
display mode shown above, your heart rate will be
shown in place of the approximate exercise pace.
As you exercise, the workout intensity level bar will
indicate the approximate intensity level of your ex-
ercise. For example, if eight of the indicators in the
bar are lit, the bar shows that your intensity level is
ideal for aerobic exercise.
To reset the console, press the Stop button, re-
move the key, and then reinsert the key.
7. Measure your heart rate if desired.
Note: If you use the handgrip pulse sensor and
the optional chest pulse sensor at the same
time, the console will not display your heart
rate accurately. For more information on the op-
tional chest pulse sensor, see page 19.
Before using
the handgrip
pulse sensor,
remove the
sheets of clear
plastic from
the metal con-
tacts. In addi-
tion, make
sure that your hands are clean.
To measure your heart rate, stand on the foot
rails and hold the metal contacts on the handrail—
avoid moving your hands. When your pulse is de-
tected, your heart rate will be shown.
For the most
accurate heart rate reading, continue to hold
the contacts for about 15 seconds.
8. Turn on the fan if desired.
The fan has high and low speed settings. Press the
Fan button repeatedly to select a fan speed or to
turn off the fan. Note: If the fan is on when the
walking belt stops, the fan will automatically turn off
after a few minutes.
9. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
when you fold the treadmill to the storage posi-
tion, or you may damage the treadmill. Next, re-
move the key from the console and put it in a secure
place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord.
IMPORTANT: If you do
not do this, the treadmill’s electrical compo-
nents may wear prematurely.
ETVM81507
(SFTL81507)
Workout Intensity Level Bar
Contacts