Navigon 7310 - Manual (Page 13)

User’s manual NAVIGON 7310
Before you begin - 13 -
Supplying power to the navigation device
Included in delivery of the NAVIGON 7310 is a car charger cable with
which power can be supplied to the navigation device via the vehicle's
cigarette lighter.
►
Connect the car charger cable to the vehicle's cigarette lighter and
to the mini USB socket of the navigation device.
Note: Plug the USB connector into the navigation device as far it will
go! (Refer to "
2
Troubleshooting" on page
2
74.)
Caution! Connect the car charger cable only to cigarette lighters with
an operating voltage of 10-24V.
The LED on the bottom of the navigation device lights up orange during
charging.
As soon as the battery is fully charged, the LED lights up green.
Note: It takes approx. 4-5 hours to charge the device when the battery
is flat.
A fully charged battery enables up to 3 hours of use depending on the
device configuration.
Removing the navigation device from the cradle
On the bottom of the plate in which you hung the navigation device is a
clip.
1. Pull the clip towards yourself so that the device is released from the
clip.
2. Lift the device up and out of the cradle.
2.5.2 TMC antenna
The NAVIGON 7310 has an integrated TMC receiver. The TMC
antenna is integrated in the car charger cable. Once the car charger
cable is connected, the device can receive current traffic messages. If
required, it can change your route dynamically, e.g. in order to avoid a
traffic jam.
2.5.3 Memory card
A memory card with the navigation software and map data is already
inserted in the navigation device.
You can copy these data to another memory card or save them on your
PC. Data backups, software updates and navigation map updates can
be carried out quickly and conveniently using the NAVIGON Fresh
software, which you can install on your computer with NAVIGON Suite
or download free of charge from our website
1
www.navigon.com .