NordicTrack NTS79020 - Manual (Page 7)

6
101
12
11
101
1
74
7
4. Attach the Backrest Frame (6) to the Base (1)
with two M10 x 82mm Button Head Bolts (74) and
two M10 Nylon Locknuts (101). Do not tighten
the Locknuts yet.
Note: The Press Arms (11, 12) are preassem-
bled in the down position (see part 12).
Throughout this manual the Arms are shown
in the raised position (see part 11). It is not
necessary to raise the Arms for assembly.
5. Attach the two Weight Guides (21) to the Weight
Base (2) with two M10 x 92mm Button Head
Bolts (90), four M10 Washers (98), and two M10
Nylon Locknuts (101).
Slide two Weight Bumpers (66) onto the Weight
Guides (21). Starting with the Large Weight (23)
marked “400”, slide the fifteen Large Weights and
the nine Small Weights (22) onto the Weight
Guides. Make sure the Weights are stacked so
the numbers are in order and on the indicated
side.
Grease the guide holes in the Top Weight (27)
with grease. Slide the Top Weight onto the Weight
Guides (21). Make sure the Top Weight is ori-
ented with the hole on the indicated side.
See the inset drawing, shown from the
reverse side of the system for clarity. Attach
the tether on the Weight Pin w/tether (67) to the
hole in the Top Weight (27) with an M8 x 19mm
Button Head Bolt (88). Insert the Weight Pin into
the stack of Weights (23).
4
21
88
67
23
5
27
27
22
Hole
Guide
Hole
Numbers
Hole
Reverse View
23
66
98
98
98
90
2
90
66
101