Cable assembly – NordicTrack NTS79020 User Manual
Page 8
8
6.
Attach two Weight Bumpers (61) to the Top
Frame (5) with two M4 x 16mm Screw (95).
8.
Attach the Top Frame (5) to the Backrest Frame
(6) with an M10 x 217mm Button Head Bolt (75)
and an M10 Nylon Locknut (101).
Tighten the M10 Nylon Locknuts (101) used in
steps 1–8.
7.
Attach the Top Frame (5) to the two Weight
Guides (21) with two M10 x 92mm Button Head
Bolts (90), four M10 Washers (98), and two M10
Nylon Locknuts (101). Do not tighten the
Locknuts yet.
Attach the Top Frame (5) to the Upright (4) with
two M10 x 70mm Button Head Bolts (87), two
M10 Washers (98), and two M10 Nylon Locknuts
(101). Do not tighten the Locknuts yet.
7
6
5
98
98
90
90
21
87
98
98
98
98
4
101
101
8
101
5
6
75
5
61
61
95
95
9.
Locate the High Cable (63), which has a bolt on
each end. Attach one end of the Cable to a “U”-
bracket (62) with an M6 Nylon Locknut (103).
Thread the Locknut onto the end of the Cable
so that two threads show past the Locknut
(see the inset drawing).
Wrap the High Cable (63) over a 3 1/2” Pulley
(56). Attach the Pulley to the Top Frame (5) with
an M10 x 46mm Button Head Bolt (76) and an
M10 Nylon Locknut (101).
9
101
76
5
56
63
63
62
62
103
103
During steps 9 through 30, refer to the
CABLE DIAGRAMS on page 21 of this man-
ual to verify proper cable routing.
Cable Assembly