NordicTrack NTBE01100 - Manual (Page 4)

4
Part Identification ChartÐModel No. NTBE01100
R1100A
M10 x 90mm Carriage Bolt (21)
M10 x 70mm Bolt (20)
M10 x 115mm Bolt (26)
M8 x 55mm Screw (16)
M8 x 16mm Screw (15)
M10 x 165mm Bolt (18)
M10 Nylon Locknut (19)
M10 Washer (28)
M8 Washer (27)
Before beginning assembly, carefully read the
following information and instructions:
¥ Assembly requires two people.
¥ Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
¥ Tighten all parts as you assemble them, unless
instructed to do otherwise.
¥ For help identifying the small parts, use the PART
IDENTIFICATION CHART, above.
¥ As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
The following tools (not included) are required
for assembly:
¥ Two (2) adjustable wrenches
¥ One (1) rubber mallet
¥ One (1) standard screwdriver
¥ One (1) phillips screwdriver
¥ Lubricant, such as grease or petroleum jelly
plus soapy water.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
Assembly