NordicTrack NTBE01100 - Manual (Page 5)

3
4
3. Attach the Main Frame (1) to the Support Plates (22)
with two M10 x 70mm Bolts (20) and two M10 Nylon
Locknuts (19). Do not tighten the Locknuts yet.
4. Press two 25mm x 40mm Inner Caps (14) into the
ends of the Right and Left Backrest Frames (3, 4).
Be sure the Left and Right Backrest Frames (3, 4)
are positioned as shown. Attach the Backrest (6) to
the Backrest Frames with four M8 x 55mm Screws
(16) and four M8 Washers (27). Do not tighten the
Screws yet.
5
1
20
19
22
14
4
27
16
14
6
14
16
16
27
3
16
27
2. Press two 76mm Round Endcaps (8) onto the ends of
the other Stabilizer (2). Press a 25mm Square Inner
Cap (24) into the indicated part of the Leg (5).
Attach the Stabilizer (2) to the Leg (5) with two M10 x
90mm Carriage Bolts (21) and two M10 Nylon
Locknuts (19).
Attach two Support Plates (22) to the Leg (5) with two
M10 x 70mm Bolts (20) and two M10 Nylon Locknuts
(19). Do not tighten the Locknuts yet.
19
24
5
8
2
21
20
19
8
22
2
1. Before assembling the bench, make sure you
understand the information in the box on page 4.
Press an Inner Cap (13) into the end of the Main
Frame (1). Press two 76mm Round Endcaps (8) onto
the ends of a Stabilizer (2).
Attach the Stabilizer (2) to the Main Frame (1) with two
M10 x 90mm Carriage Bolts (21) and two M10 Nylon
Locknuts (19). Do not tighten the Nylon Locknuts
yet. Note: The indentions in the Stabilizer should
face the floor so that the warning decal is in the
position shown.
1
21
8
8
19
2
13
19
Warning Decal
1