New Holland AUTO COMMAND T7OOO - Manual (Page 8)

• Activate IntelliSteer™ system – push button to Activate IntelliSteer system push button to •
engage automatic guidance system. A choice
of correctional signals is available. With an RTK
signal, the tractor will steer itself with a pass to
pass accuracy of between 1 cm to 2 cm.
• Electro hydraulic remote controls –
fingertip control of two remote valves.
• Headland T • u T T rn Sequence and engine speed
management control. Activates the pre-recor d ded
Headland Tu T T rn Sequence or alter the natively allows
s. operator to switch between two set engine speeds
• Rear linkage raise and lower • .
• Powershuttle switch – Finger • tip dir e. ection change
• Cruise contr ion ol – Auto Command™ transmiss
works automatically to optimise perfor e. mance
• T • a T T rget speed selection – allows you
to change between three target speeds.
• Ta T T eed rget speed adjustment – set a target spe
e, to match your exact needs. As an example
it is useful when moving between
differentfields or where crop
yields have altered.
•
•
•
CONTINUOUSLY VARIABLE TRANSMISSION
FOR BEST PRODUCTIVITY AND FUEL SAVINGS
The CommandGrip™ handle provides access to all major controls. It shares the
same ergonomic design as the proven CommandGrip™ handle used in New Holland
FR forage harvesters. A key advantage of the design is that it enables a range of
tasks to be completed together. This can include adjusting the tractor’s speed,
raising the linkage, operating the remote valves or activating automated functions.
AUTO COMMAND™ TRANSMISSION 8 9
INTELLIVIEW III SHOWS YO Y Y U
ALL YO Y Y R SPEED SETTINGS
Intelliview III will show the direction of
travel, three set target speeds and
selected driving mode. All relevant
information is easy to see at a glance.