NordicTrack 30505.0 - Manual (Page 7)

ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench and your own Phillips screwdriver . For
help identifying the assembly hardware, see the hardware drawings below.
7
1. Raise the end of the Frame (not shown) until the tread-
mill can be moved on the front Wheels (66), and care-
fully roll the treadmill off the wood pallet.
Insert the Wire Harness (108) and the TV Cable (109)
through the Upright Plate (115).
With the help of a second person, hold the Upright (111)
and the Upright Plate (115) against the Frame Cover
(52).
See the inset drawing and make sure that the
Upright is oriented at the angle shown and the
Upright Plate is oriented as shown. Attach the
Upright and the Upright Plate with four Upright Bolts
(113) with two Star Washers (114).
Make sure that the
Upright Bolts are inserted strait into the Upright and
Frame Cover. Do not tighten the Upright Bolts yet.
ew (123)–2
U
Spacer Screw (60)–2
1
Washer (116)–4
Console Bolt (110)–4
F
3/4” Tek Screw
(91)–4
Upright Bolt (113)–4
F
Panel Screw
(139)–3
Handrail Bracket Bolt (31)–4
P
Handrail Bolt (90)–4
Star Washer
(114)–4
114
114
115
52
66
113
109
111
108
1
111
115