NEC pmn - Manual (Page 13)

Installation
Connection to your Personal Computer
The MultiSync LCD 400 /LCD 2000 true colour monitor complements PC
compatible computers. Your system has one of two configurations:
– the video controller is built into the computer.
– the video controller is in the form of a display card (sometimes
referred to as graphics card, video adapter or graphics board).
Both configurations have a video connector (or a CRT PORT on laptop
computers). If you are not sure which connector is the video connector,
refer to your computer or display card manual.
To attach the monitor to your system, follow these instructions:
1. Turn off the power to the monitor and computer.
2. If necessary, install the display card. For more information
about installing your card, refer to the display card manual.
3. Connect the 15-pin mini D-SUB of the appropriate signal
cable to the connector of the display card in your computer.
Tighten all srews.
4. For the LCD 400 : Connect the 15-pin mini D-SUB of the
video signal cable to the appropriate connector on the back of
the monitor.
For the LCD
2000 : Connect the BNC cable to the appropriate
connectors on the back of the monitor. Connect the red BNC
cable to the BNC connector on the monitor labelled R, the green
BNC cable to the BNC connector on the monitor labelled
G/Sync, the blue BNC cable to the BNC connector on the
monitor labelled B. If you have a fourth BNC connector
(Composite Sync), connect it to the BNC connector on the
monitor labelled H/CS. If you have a fifth BNC connector
(Vertical Sync), connect it to the BNC connector on the monitor
labelled VS.
E - 6 Installation