NEC pmn - Manual (Page 14)

Note: Incorrect cable connections may result in irregular operation,
damage display quality/components of LCD module and/or shorten the
module’s life.
5. Connect one end of the power cable to the MultiSync LCD
monitor and the other end to the power outlet.
6. Turn on the monitor and the computer.
7. This completes the installation.
If you have any problems, please refer to the Troubleshooting section of
this manual.
Connection to your Personal Computer (Macintosh)
With the Macintosh cable adapter, the MultiSync LCD 400 /LCD 2000
colour monitor is compatible with the Macintosh family of computers.
You will connect your MultiSync colour monitor one of two ways to
your Macintosh computer:
– On-board video port
– NuBus/PCI/PDS display card
Both configurations should have the same style video connector. If you
are not sure which port is the monitor connector, please reference your
computer or display card manual.
To attach the monitor to your system, follow these instructions:
1. Turn off the power to your MultiSync LCD monitor and
Macintosh.
2. If necessary, install the display card. For more information on
this installation, reference the display card manual.
3. Connect the MultiSync LCD 400 or MultiSync LCD 2000
Macintosh cable adapter to the computer. Attach the 15-pin
mini D-SUB end of the appropriate signal cable to the
Macintosh cable adapter. Tighten all srews.
Installation E - 7