Northern Industrial Tools Item# 145765 - Manual (Page 6)

3. Quick-set vise clamp.
x, you have to wait till the machine stops running. Then
that you do not shift the speed while cutting.
500
that,
To insert the location pin smoothly, move the saw blade back and forth, bringing the shifting
andle to a suitable location where you can insert the location pin into the locate hole.
st locks.
tating the handle.
p and lower with the hydraulic flow control.
te level.
r you finish work.
ting to the desired position.
rtical position in the following
0” table (an option that may be purchased from your dealer) to the guide bar
using the screws provided and the guide bar knob.
4. Low noise level during operating.
Note:
If you want to shift the speed of the gear bo
you may operate the shifting. Please make sure
Please check the engine oil of the gearbox
regularly.
Change the #80-#90 engine oil every
working hours.
Steps for operating the gearbox:
1. Before you shift the speed, you have to cut
off the source of the electricity, then you may check if the motor stops running completely. After
remove the saw blade from the piece of work.
2.
h
OPERATION
WORK SET UP
1. Raise the saw arch to a 45ºposition with the table and built-in steady re
2. Open the vise to clamp the workpiece to be cut securely by ro
3. Use a sliding bracket to keep balance if the workpiece is too long.
4. Select the adequate speed for the material you are cutting.
5. Switch on the power and lift the saw arch to the to
6. Adjust the coolant & lubricant switch to the appropria
7. Turn off the power supply afte
NOTE:
Never turn off the motor when blade is cutting.
WORK STOP ADJUSTMENT
1. Loosen the thumb screw holding the work stop casting to the shaft.
2. Adjust the work stop cas
3. Rotate the work stop to as close to the bottom of the cut as possible.
4. Tighten thumb screw.
5. DO NOT ALLOW the blade to rest on the work while the motor is shut off.
CONVERTING FOR VERTICAL USE
Notching slitting, contour work may be done with the saw in the ve
manors:
1. Rotate the head to the vertical position.
2. Assemble a 10”x1
Page 5 of 15