Nortel WLAN IP 2210 - Manual (Page 26)

26 Chapter 2 WLAN Handsets overview
NN40050-101 NN40050-101
7 Press the Select button (or OK) to select the highlighted setting.
8 Do one of the following:
• Press UP to return to the previous menu and configure another option.
• Press to exit all menus and return to the standby state.
You can also press Exit from the top-level menu to exit the menu and return to the active
(off-hook) state.
Configure push-to-talk
Push-to-talk is available on the WLAN Handset 2211 only.
Push-to-talk mode enables two-way radio communication with another WLAN Handset 2211
user. You can enable/disable Push-to-Talk mode and select a channel.
To configure Push-to-Talk for the handset
1 Press when the handset is in the standby state.
2 Press the Up and Down buttons to scroll through the menu and highlight Push-to-Talk .
3 Press the Select button (or OK) to select Push-to-Talk .
4 Press the Up and Down buttons to scroll through the menu and highlight Enable/Disable .
5 Press the Select button (or OK) to select Enable/Disable .
6 Press the Up and Down buttons to scroll through the menu and highlight one of the following
settings:
• PTT Enable — Enables Push-to-Talk mode.
• PTT Disable — Disables Push-to-Talk mode. This is the default.
7 Press the Select button (or OK) to select the highlighted option.
8 Press the Up soft key to return to the previous menu.
9 Press the Up and Down buttons to scroll through the menu and highlight Channel .
10 Use the Up and Down buttons to scroll through the menu and highlight a channel (1 to 8).
11 Press the Select button (or OK) to select the channel.
12 Do one of the following:
• Press UP to return to the previous menu and configure another option.
• Press to exit all menus and return to the standby state.
You can also press Exit from the top-level menu to exit the menu and return to the active
(off-hook) state.