Nortel Networks COOLPIX S8000 User Manual
Page 44
32
Using the Flash
Bas
ic Ph
otography an
d Pl
ayba
ck
: A
(Auto)
M
o
de
C
The Flash Lamp
The flash lamp indicates flash status when the shutter-
release button is pressed halfway.
• On: Flash will fire when picture is taken.
• Blinks: Flash charging. Wait a few seconds and try again.
• Off: Flash will not fire when picture is taken.
If the battery is low, the monitor display will turn off, and
remain off, until the flash is fully charged.
C
The Flash Mode Setting
The default flash mode setting varies with shooting mode.
• A (auto): U (auto)
• Scene: varies with the selected scene mode (
• F (smart portrait): U (auto) when Off is selected for Blink proof (
A 69); fixed at W (off) when
On is selected for Blink proof
• s (subject tracking): W (off)
There may be functions with which the flash cannot be enabled. See “Camera Settings that Cannot
Be Applied Simultaneously” (
A 53) for more information.
The flash mode setting applied in A (auto) mode is stored in the camera’s memory even after the
camera is turned off, and reapplied the next time A (auto) mode is selected.
C
Red-eye Reduction
This camera uses advanced red-eye reduction (“In-Camera Red-Eye Fix”). If the camera detects “red
eye” while a picture is being recorded, the affected area will be processed to reduce red-eye before
the picture is saved. Note the followings when shooting.
• More time than usual is required to record pictures.
• Red-eye reduction may not produce the desired results in all situations.
• In extremely rare instances, areas not subject to red-eye may be affected by red-eye reduction
processing; in these cases, choose another flash mode and try again.