NETGEAR ADSL Modem DM602 - Manual (Page 30)

Reference Manual for the Model DM602 ADSL Modem
3-6 Preparing Your Computer
6. Select ‘Internet Protocol (TCP/IP)’, click Properties, and verify that “Obtain an IP address
automatically is selected.
7. Click OK and close all Network and Dialup Connections windows.
8. Make sure your PC is connected to the modem, then reboot your PC.
Verifying TCP/IP Properties
To check your PC’s TCP/IP configuration:
1. On the Windows taskbar, click the Start button, and then click Run.
The Run window opens.
2. Type cmd and then click OK.
A command window opens
3. Type ipconfig /all
Your IP Configuration information will be listed, and should match the values below if you are
using the default TCP/IP settings that NETGEAR recommends:
• IP addresses—192.168.0.2 through 192.168.0.254
• The subnet mask is 255.255.255.0
• The default gateway is 192.168.0.1
4. Type exit
Configuring A Macintosh for TCP/IP Networking
Beginning with Macintosh Operating System 7, TCP/IP is already installed on the Macintosh. On
the Macintosh, you will need to configure TCP/IP to use DHCP.
Configuring MacOS 8.6 or 9.x for TCP/IP Networking
1. From the Apple menu, select Control Panels, then TCP/IP.
DM602.book Page 6 Monday, August 12, 2002 6:09 PM