NordicTrack ELITE NTL15007.0 - Manual (Page 7)

7
2. Identify the Left Upright (73) and the Right
Upright (74).
See the inset drawing. Tie the wire tie in the
Right Upright (74 securely around the end of the
Upright Wire Harness (75). With the help of a
second person, hold the Right Upright near the
Right Base Cover (77). Then, pull the other end
of the wire tie up through the rectangular hole in
the bottom of the Right Upright until the Upright
Wire Harness is routed completely through the
Right Upright.
Gently pull up on the Upright Wire Harness (75)
as you set the Right Upright (74) on the Base
(83) inside the Right Base Cover (77).
Be care-
ful not to pinch the Upright Wire Harness.
Partially attach the Right Upright (74) to the
Base (83) with two Upright Bolts (72) and two
Upright Star Washers (90).
Do not tighten the
Bolts yet. Note: It may be necessary to tip the
tops of the Uprights forward slightly as you
thread the Upright Bolts into the Uprights.
Attach the Left Upright (73) to the Base (83) with
two Upright Bolts and two Upright Star Washers
(not shown).
Do not tighten the Bolts yet.
With the help of a second person, lower the
treadmill off the cardboard stand.
83
75
Wire
Tie
77
2
74
73
90
72
3. Identify the Right Upright Sleeve (96) and the
Left Upright Sleeve (95). Both are labeled. Slide
the Right Upright Sleeve onto the Right Upright
(74) and the Left Upright Sleeve onto the Left
Upright (73).
95
“Right”
“Left”
96
3
74
73
75
74
Wire Tie