NETGEAR DS508 - Manual (Page 9)

Model DS508/DS516/DS524 Dual Speed Stackable Hub Installation Guide
Install the Hub on a Flat Surface
If installing the hub on a flat surface such as a tabletop, make sure the bottom of the chassis is
clean and dry and allow at least 2 inches of space on all sides of the hub to ensure proper
ventilation.
1. Install the self-adhesive footpads on the bottom of the hub.
2. Set the hub on a table or shelf so that it has at least 2 inches
(5 cm) of space on all sides.
3. Connect the power cord(s) first to the power entry receptacle on the hub rear panel and
then to the wall.
Install the Hub in a Rack
To install the hub in a rack, make sure you have #2 and #3 Phillips screwdrivers. Refer to the
illustration and follow the steps.
1. Attach the mounting brackets (supplied in the rack mount kit) to the sides of the hub
using the screws provided.
2. Attach the hub (with the mounting brackets) to the rack using two panhead screws with
nylon washers.
Installation Procedures
Install the Hub
8145FA
Normal/U plink 24
12 Link RX
Link RX
17
5 Link RX
13
1
Power D ata Collisio n
#3 Phillips screwdriver
(use large screws with spacers) #2 Phillips screwdriver
(use small screws)