Nady Systems CX-23SW - Manual (Page 5)

F U S E 0 . 5 A / 2 5 0 V H I G H H I G H M I D M I D L O W L O W
O U T P U T S I N P U T I N P U T R C H A N N E L O U T P U T S L C H A N N E L S U B W O O F E R
Emeryville, CA, USA
Made in China
NADY SYSTEMS, Inc.
ATTENTION: SHOCK HAZARD - DO NOT OPEN
RISQUE DE CHOC ELECTRIQUE NE PAS QUVRIR.
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN
115V/60Hz
230V/50Hz
XLR
BALANCE
PIN 1 GND
PIN 2 HI
PIN 3 LO
AC IN
Crossover Type ..................................................................................Stereo 3 ways + Subwoofer
Crossover Frequencies Subwoofer..................................................50 - 250Hz
LM ........................................................................................................70 – 1000Hz
MH........................................................................................................480 – 7000Hz
Filter Type (Slope) ..............................................................................2nd order, 12dB/Octave
Inputs Type ........................................................................................Balanced Combo 1/4” TRS & XLR
Impedance ..........................................................................................100K
Ω
Outputs Type ......................................................................................Balanced XLR
Impedance ..........................................................................................220
Ω
Low Cut Filters ..................................................................................30Hz/ - 3dB, 12dB/Octave
Frequency Response ........................................................................25Hz - 25KHz +/-1dB
Total Harmonic Distortion (THD) + Noise ......................................< 0.05 %
S/N Ratio ............................................................................................> 80 dB
Fuse ....................................................................................................0.5 A/ 250V, 5x20mm glass type
Dimensions ........................................................................................19’’ x 1.73’’ x 5.9’’ (483 X 44 X 150mm)
Weight ................................................................................................4.4 lbs. (2.2 Kg)
10. POWER CONNECTOR
The IEC jack is used to connect the power cord to the AC Power Source.
(Caution: Do not remove the center grounding pin.)
11. L/M/H OUTPUT CONNECTORS:
Connect to your amplifiers via these balanced XLR output jacks.
12. BALANCED INPUT CONNECTORS (Combo 1/4” TRS & XLR):
Connect your L/R stereo input signal to these balanced combo jacks. These combination 1/4” TRS (Tip/Ring/Sleeve)
phone jacks and XLR jacks are compatible with either type balanced connector and are wired as Tip/Pin 3 = (+),
Ring/Pin 2 = (-), and Sleeve/Pin 1 = Ground.
13. SUBWOOFER OUTPUT CONNECTOR:
Connect to your subwoofer amplifier via this balanced XLR output jack.
14. AC VOLTAGE SELECTOR SWITCH:
Before plugging in the power cord, check to see that the unit is set for the proper voltage for your area: ~115V (60Hz)
or ~230V (50Hz).
15. FUSE COMPARTMENT :
Replace with only the same type fuse (0.5A/250V). If it blows continuously, do not use the unit until it has been serv-
iced by qualified personnel.
Specifications and design subject to change without prior notice for improvement purposes
5
REAR PANEL
14 15
11
12
CONTROLS AND CONNECTIONS
SPECIFICATIONS
10
13
11
12