NEC NEAX 2000 IPS - Manual (Page 33)

Chapter 2 System Configuration LAN Cable Connection of ETHER Card
NEAX 2000 IPS Configuration Guide
NDA-24347, Issue 1
Page 23
LAN Cable Connection of ETHER Card
Connect the LAN connector on the ETHER card and the Router/Switching HUB by
using a 10 BASE-T/100 BASE-TX cable.
When the system provides Dterm IP/OAI terminal/MAT on the LAN, connect them to
Switching HUB, which is connected to the LAN connector on the ETHER card.
Figure 2-13 ETHER - Router/Switching HUB Cable Connection
Note:
The port number of the NEAX 2000 IPS for OAI is fixed to 60030 and for MAT
is fixed to 60000.
ETHER
LAN
100 BASE-TX Cable
Maximum 328 ft. (100 m)
Dterm IP
OAI
MAT
Pins (RJ-45 Connector)
8 Not used
7 Not used
6 RD -
5 Not used
4 Not used
3 RD +
2 TD -
1 TD +
Pins (RJ-45 Connector)
Router/Switching HUB