Nilfisk-Advance America Sweeper SR 1700D 2W D - Manual (Page 52)

USER MANUAL
14 33014815(1)2005-07 A
PERIODICAL CHECKS
Battery
Check the electrolyte level.
Check the battery poles for oxidation.
Clean the entire surface of the battery with a damp sponge.
Tyre pressure
Front wheels
Recommended pressure: 7 Bar
Rear wheels
Recommended pressure: 7 Bar
Fluid levels
Brake fluid: DOT4
Hydraulic oil: AGIP Arnica 46
Engine oil:
AGIP Sigma Turbo 15W/40 K180
Coolant level
Mixture: 50% AGIP antifreeze and 50% water
Skirt closing adjustment
– Loosen the locknut (1, Fig. M).
– Adjust the fastener, making sure that the skirt closing
panel closes hermetically.
– Adjust the skirt spring pressure with the mounting screw
(2, Fig. M).
Parking brake adjustment
– Loosen or pull the nut (1, Fig. N) avoiding to move the
cable end.
– Adjusting the cable tension, make sure the brake is not
locked.
Air cleaner replacement
– Unscrew the mounting screw (1, Fig. O) and remove the
cover (2).
– Unscrew the air cleaner (2, Fig. P) setscrew (1).
– Remove, clean or replace the air cleaner.
– Unscrew the element (2, Fig. Q) setscrew (1).
– Remove, clean or replace the element.
– Reinstall the cover and tighten the screw.
Gear pump hydraulic oil filter replacement
– Empty the oil tank through the plug at the bottom.
– Remove the tank cover (1, Fig. R).
– Unscrew the filters (1, Fig. S) from their seats inside the
tank.
– Screw the new filters into place using the appropriate
wrench (50) and reinstall the tank cover.
– Screw the drain plug.
– Check the oil level and top it up if necessary.
Variable delivery pump hydraulic oil filter
replacement
1. Unscrew the mounting screw.
2. Unscrew the filter (1, Fig. T) and place it in a container
for special waste. Replace it with an original filter.
Hydrostatic pump hydraulic oil filter replacement
V belt check
Oil filter element replacement
Fuel filter element replacement
Hydrostatic pump hydraulic oil filter replacement
Fuel screw and fitting tightening
Injector check
Glow plug check
Engine air cleaner replacement
Fuel tank cleaning
Alternator belt replacement
Hydraulic oil change
Starter brush replacement
Hydraulic motor and pump pressure check
Sealing gasket wear check
Brake system check
Moving part clearance check
Maintenance
Every 10
hours
After 50
hours
Every 150
hours
Every 300
hours
Every 500
hours
Every
1,000
hours
Every
2,000
hours
WARNING!
Wear gloves and goggles.
WARNING!
Do not pollute the environment with used oils
and filters.
WARNING!
Do not pollute the environment with used oils
and filters.