Preparing your device for use, Charging the battery, Power interruptions – Navigon 2090S User Manual
Page 26
Getting Started
Preparing your Device for use
10
NAVIGON 2000S | 2200T Series User’s Guide
December 2008
NAVIGON, INC.
Version 1.1
Preparing your Device for use
Charging the battery
•
Connect the car charger cable to the navigation device and to the vehicle’s ciga-
rette lighter.
Power Interruptions
When power to the device is interrupted, the NAVIGON device can be configured to
put itself into Standby mode to save power. This occurs when the device is on and is
disconnected from a power source, such as:
•
The vehicle cigarette lighter, or
•
A wall outlet.
With this option, after a power interruption, the device waits 30 seconds, then puts
itself into Standby mode. When one of the above power interruptions occur, the follow-
ing message displays a 30 second countdown:
Tap:
•
OK or wait until the 30 seconds countdown completes to allow the device to enter
Standby mode.
•
Cancel to end the countdown and continue using the device.
Note:
A 12 volt car charger cable is included with your device. An A/C wall charger is
also available as an optional accessory. Visit our web store
www.navigonusa.com/store/
.
For more information on setting this option, see Automatic Standby in “General Set-
tings” on page 97.