National Mower 68 DL - Manual (Page 9)

NATIONAL 68 SR & DL TRIPLEX ®
9
68OM-06/03
07595 – MANUFACTURER & SOUND LEVELS
(located on left side of main belt guard)
Guaranteed sound power level and manufacturer’s
information
07415 – MODEL 68 DL LABEL (68 DL only)
07598 – MODEL 68 SR LABEL (68 SR only
(located on left side of engine belt guard and right side of
main belt guard)
07600 – CUTTING UNIT DANGER
(located on top surface of each cutting unit)
Reels and bed knives on the cutting
units are sharp. Keep hands and
feet away from the cutting units.
Do not attempt to work around the
cutting units while they are running.
Your fingers, hands, arms, or any loose clothing may
become entangled in the belt drives. Do not operate
the cutting units unless you are seated on the mower.
Keep all guards and shields in place.
07083 – SERIAL NUMBER DATA PLATE
(located on mower frame, left side, below seat)
205341 – INSTRUCTIONS for OPTIONAL DIAL-A-
HEIGHT ADJUSTER
(located on the top shield of each cutting unit)
Raise and turn the adjuster knob counterclockwise to
lower the height of cut. Raise and turn the adjuster knob
clockwise to raise the height of cut. Read the instructions
for the Dial-A-Height adjusters in the Operations section
of this manual.
DANGER
DANGER
07590 – REAR CUTTING UNIT CLUTCH
(located on top surface of rear cutting unit)
Pull lever forward and toward the center of the machine
to engage sliding jaw clutch.
To disengage, pull lever forward and out to engage
locking pin.
Never engage the drive unless the rear cutting unit has
been lowered to the cutting position.
(Note that the decal is viewed properly while looking
toward the rear of the mower.)